Focused on compressed air system design, air treatment, piping configuration, equipment maintenance, and common industrial air issues, with practical guidance based on pressure, flow, dew point, air quality, and operating conditions for equipment selection, system optimization, and routine operation and maintenance.
Remember the baseline of 3000 hours, the poor environment will be shortened, and the good environment can be extended appropriately. At the same time, keep an eye on the indicator of pressure difference and change it when it comes.
General air compressor gas production and power ratio, in the most popular words is: every 1 kW of power, about every minute can produce 0.15 to 0.18 cubic meters of compressed air. On the other hand, if you want the machine to spit out 1 cubic meter of gas per minute, you need to consume about 5.5 to 7 kW of electricity.
Long-term idleness will definitely break down, but the water-lubricated air compressor has less big trouble of oil deterioration, and the overall damage degree is lighter than that of oil-lubricated machines, and the maintenance is more worry-free.
The role of explosion-proof screw air compressor is to supply air normally in dangerous environment while ensuring that it will not become the fuse of explosion. Water-lubricated air compressor is born without the flammable factor of oil, which is more reassuring than traditional oil-lubricated machines in explosion-proof scenes, and daily maintenance is simpler.
The oil and gas separator is generally recommended to be changed every 3000 to 4000 hours of operation. If the use environment is dusty and humid, this time will be shortened again, and it may have to be changed in about 2000 hours.
The drainage of the water-lubricated air compressor belongs to the production wastewater, but because it uses water as the medium and does not introduce oil pollution, it is much more friendly than the oil-lubricated air compressor in the wastewater treatment process and the treatment cost is lower.
During yeast fermentation, a certain pressure needs to be maintained in the tank. This pressure is not too high, which is probably a little higher than the external atmospheric pressure. The purpose of this is to prevent the outside bacteria and air from pouring in, while allowing the gas produced during the fermentation process to be discharged smoothly.
The screw air compressor provides all the places where gas is needed for the foundry. The water-lubricated screw machine has no oil and the gas discharged is cleaner, which is especially suitable for scenes that require the surface quality of castings.
Whether you can directly drain the rainwater pipe network depends on your environmental protection regulations. In some places, this kind of relatively clean condensate is allowed to be discharged directly, and in some places, no matter what water is required to enter the sewage pipe network. In addition, the cold dryer and the suction dryer will also produce condensed water, which is also very clean and similar to the water discharged from the water-lubricated air compressor.
The environmental core of explosion-proof air compressor is to eliminate all ignition sources. Water lubricated air compressor is naturally more suitable for this dangerous environment than oil injection machine because there is no oil.
