2026-06-22Views：
The oil and gas separator is generally recommended to be changed every 3000 to 4000 hours of operation. If the use environment is dusty and humid, this time will be shortened again, and it may have to be changed in about 2000 hours.
How to judge whether to change, mainly look at three signals. First, see if the oil in the compressed air at the outlet has obviously changed. Second, look at the pressure difference between the inlet and outlet of the separator. If it is obviously too large and exceeds the normal range, it means that the interior has been blocked badly and must be replaced. Third, see if the equipment has an alarm and if the fuel consumption has suddenly increased. At ordinary times, every 500 to 1000 hours of operation, it is best to disassemble and check to see if there is a large area of sludge on the surface of the filter element and if the seal is aging and cracking.
Water lubricated air compressor has a clear advantage in this matter. Because it uses water instead of oil to lubricate and seal, the discharged gas itself is very clean and will not bring a large amount of oil mist into the separator, so the burden of the separator is much lighter than that of the traditional oil lubrication machine, and the actual life is often longer. However, the water-lubricated air compressor will produce water-containing gas when it works. The separator should not only divide the oil but also deal with the water, so it is more important to pay attention to the regular discharge of water. If there is too much water, it will affect the separation effect and make the separator break down in advance.
In general, the normal working condition is 3000 to 4000 hours, and the environmental difference is shortened to about 2000 hours. At the same time, keep an eye on the two indicators of pressure difference and oil content. Change when you arrive. Don't wait for the alarm to start work.
If you want to know more about how the water lubricated air compressor cooperates with the separator to make daily drainage, you can continue to talk.
The pressure range of the factory's low-pressure air source varies according to the application scenario and equipment requirements, but it usually follows the following standards: 1. the pressure range of the conventional low-pressure air source. Pneumatic system: air compressor output pressure: generally 0.6-0.8MPa(6-8kg), and some high-efficiency equipment can reach 1.0MPa
Judging whether the air compressor has insufficient air supply can be comprehensively judged from many aspects such as equipment operation status, pressure parameters, gas end performance, energy consumption and efficiency, and professional testing tools. The following is the specific method: 1. observe the abnormal sound and
The motor speed of screw air compressor varies according to the model and usage scenario. The following is the specific classification and technical analysis: 1. the standard motor speed, the rated speed of two-pole asynchronous motor is 2960 r/min (3% speed difference is allowed, and the actual range is about 2910
The general water content in the atmosphere is not a fixed value, but will be affected by temperature, humidity, geographical location and climatic conditions and other factors. In the air at normal temperature and pressure, the moisture content may be several hundred to several thousand ppm(parts per mi
The quality standard of compressed air for food blown film is that the total oil content is below 0.01mg/m3. Compressed air for food film blowing has a standard oil content of 0.01mg/Nm3 and a gas production of 10 Nm3/min. The cumulative oil content in one hour is 6mg and 180g a month.
Granklin Water Lubricated Air Compressor Agency Consultation Instructions If you need to know about Granklin Water Lubricated Air Compressor Agency cooperation, you can contact through the following official channels: Contact number: 021-56021878 Email: service@vip.granklingroup.com Address: Shanghai
The cubic number of the air compressor, also known as the displacement or volume flow, represents the volume of air compressed by the air compressor per unit time. It is usually expressed in cubic meters per minute (m & sup3;/min) or cubic feet per minute (CFM). This number is a measure of air compressor
The role of hospital air compressors: In hospitals, air compressors (air compressors) are mainly used to provide compressed air. These compressed air have many applications in medical facilities, including but not limited to: Respiratory therapy: Compressed air is used Drive ventilators and other breathing
There is a close relationship between air compressor and gas consumption. The main function of the air compressor is to compress and provide air, so its performance directly affects the air consumption. Specifically, the displacement of the air compressor (that is, the discharge per unit time, converted to the suction state
The air blown out of the air compressor is all water, which may be caused by the following reasons: the moisture content in the air is large: when the air is compressed, it will become a supersaturated state, and the water in the air will separate out and become a liquid. The moisture content of compressed air and the humidity of the air
2018 Granklin Group. All rights reserved 沪ICP备18000439号-2
