Start sequence of air compressor and dryer

The starting sequence of the air compressor and dryer shall follow the following steps:

start the air compressor:

first, make sure that the air inlet valve is open to ensure that air can enter the compressor smoothly.

Turn on the power switch to provide power for the air compressor.

Start the main engine of the air compressor and observe the running status of the main engine to ensure its normal operation.

Adjust the pressure regulator gradually as needed to achieve the required working pressure.

After the pressure is stable, the air compressor can be used normally.

Start the dryer:

after the air compressor runs stably, start the dryer again. This is because the dryer needs a stable supply of compressed air to work, and the air compressor is the equipment that provides this supply.

If the dryer is turned on first, the water vapor and liquid water generated during the operation of the air compressor may affect the normal operation of the dryer and reduce its dehumidification effect.

To sum up, the correct starting sequence is to start the air compressor first, and then start the dryer after its operation is stable, so as to ensure the normal operation of the two and the quality of compressed air. In actual operation, refer to the specific equipment operating instructions or consult a professional to ensure correct operation.