2026-04-09Views：
The quality standard of compressed air for food blown film is that the total oil content is below 0.01mg/m3.
Compressed air for food film blowing has a standard oil content of 0.01mg/Nm3 and a gas production of 10 Nm3/min. The cumulative oil content in one hour is 6mg, 180g a month, equivalent to 200mL of lubricating oil, and an oil film of 250000m2 can be formed.
the use of compressed air:
if there is moisture and oil in the compressed air, it will bring many follow-up problems to the use of equipment: increase the cost of operation and maintenance, reduce the efficiency of the equipment, and affect the quality of the production process, so in the compressed air source purification treatment system in the removal of water and oil is a necessary and important link.
If conditions permit, you can choose the water-lubricated air compressor of Shanghai Granklin Group, and the compressed gas produced does not contain oil.
Whether air compressor maintenance requires a special maintenance unit, according to the type of equipment, enterprise technical ability and cost-effectiveness of comprehensive judgment, but it is recommended to choose a professional maintenance unit to ensure the stable operation of the equipment and extend the service life. The following is a detailed analysis of the problem
There is no fixed standard for the running time of the explosion-proof air compressor, because it is affected by many factors, including the design of the air compressor, the use of the environment, the load situation, the maintenance condition, etc. However, in general, high-quality explosion-proof air compressor in the design
The air compressor does not pump air (or called "unable to pump air", "insufficient pressure", etc.) may be caused by a variety of reasons. The following are some common causes and their corresponding solutions: 1. electrical problems Power lines or power switches
For the question of whether the 2 cubic compressed air storage tank needs to be reported, the answer depends on the design pressure of the storage tank and other relevant factors. If the design pressure of the gas storage tank is greater than 1kg (or 0.1 MPa), it needs to be reported according to relevant regulations.
Air compressor application-intensive plant type analysis As the basic power equipment in the industrial field, air compressors are widely used in various production scenarios. Combined with industry general data and typical cases, the following plant types have the most intensive demand for air compressors: 1.
Whether the air compressor room needs anti-explosion or not involves many considerations. The following is a detailed analysis of this problem: Risk analysis of 1. air compressor room Explosion risk: During the operation of the air compressor, if the operation is improper Or the equipment is defective, it is possible
Whether the oil core needs to be replaced for the first maintenance of the screw air compressor shall be comprehensively judged according to the following specifications: 1. to the manufacturer's standard industry routine. Most brands stipulate that the lubricating oil, oil filter and air filter shall be replaced for the first maintenance (500 hours), but the oil core is usually not covered by the first insurance.
In the fermentation process, there are certain requirements for air quality, especially the oil content in the air, because too high oil content may have a negative impact on the fermentation process. The following are the relevant points about the oil content of the air used for fermentation: oil content standard: root
Safety Operation Regulations for Air Compressors Before 1. Startup 1. Check whether each moving part is flexible, whether each connecting part is fastened, whether the lubrication system is normal, and whether the motor and electrical control equipment are safe and reliable. 2. Check the air compressor before operation
The difference between oil and oil-free air compressors is mainly reflected in the following aspects: 1. working principle Oil-based air compressor: Lubricating oil needs to be added during the compression process. Lubricating oil not only plays a lubricating role, reduces friction, but also improves work efficiency. but at the same time
2018 Granklin Group. All rights reserved 沪ICP备18000439号-2
