High exhaust temperature alarm of cold dryer

Cold dryer exhaust high temperature alarm may be caused by a variety of reasons, the following are some possible reasons and the corresponding solutions:

equipment failure:

the condenser is blocked or not cleaned thoroughly: This will cause the heat to not be dissipated properly, which will trigger the high temperature alarm. The condenser should be checked regularly and cleaned thoroughly.

Compressor or fan damage: the abnormal operation of these important components will affect the cooling effect of the cold dryer. Check whether the compressor and fan are running normally, and replace or repair them in time if there is any fault.

Running status is abnormal:

overload or overheating: If the cold dryer runs for too long or is overloaded, especially in summer high temperature weather, it is easy to cause high temperature alarm. The running state should be adjusted to avoid long running time or heavy load.

Unstable supply voltage: This may cause the device to overheat. In the case of unstable power supply voltage, voltage stabilizer should be used to ensure the normal power supply of the equipment.

Environmental issues:

too much dust around the cold dryer: dust adsorbed on the cooling fins will hinder heat dissipation, resulting in high temperature shutdown. The cooling fins should be cleaned regularly.

Poor ventilation in air compressor room: poor ventilation can easily lead to high temperature jump of cold dryer. Ventilation conditions should be improved, such as setting up separate air ducts, installing fans or fans, etc.

The cold dryer is placed outdoors and exposed to direct sunlight: this will cause the equipment to overheat and shut down. Awning shall be made above the cold dryer to avoid direct exposure to the sun.

To sum up, to solve the problem of high temperature alarm of cold dryer exhaust needs to start from many aspects, including checking equipment failure, adjusting the operating state and improving the operating environment of the equipment. If the above methods still cannot solve the problem, it is recommended to contact professional technicians for further inspection and maintenance.