Start and stop sequence of air compressor and adsorption dryer

The start and stop sequence of air compressor and adsorption dryer is as follows:

start sequence:

start the air compressor first. The air compressor is the core equipment of the air compressor station, which is responsible for providing compressed air. Therefore, when starting the entire air compressor station system, the air compressor should be started first.

When the air compressor runs stably, and the output compressed air pressure, temperature and other parameters reach the preset value, then start the adsorption dryer. This is because the adsorption dryer needs to use the compressed air output of the air compressor. If the air compressor is not started or the operation is unstable, it will directly affect the normal operation of the adsorption dryer.

Stop sequence:

when stopping the whole air compressor station system, the air compressor shall be stopped first.

When the air compressor is completely stopped, stop the adsorption dryer. This can ensure the safety and stability of the entire air compression station system.

Please note that the above start-stop sequence is based on general air compression station system configuration and operation experience. In actual operation, it should also be adjusted and optimized according to the specific equipment model, manufacturer's requirements and the actual situation on site. At the same time, in order to ensure the safe and stable operation of the air compression station system, the equipment should be maintained regularly to find and deal with potential problems in time.

In addition, for complex air compression systems, it is recommended to refer to the equipment's operating manual or contact the equipment manufacturer for accurate start-stop sequences and operating instructions.