Screw air compressor shows that the host is not balanced

When the screw air compressor shows that the host is unbalanced, it may be caused by a variety of factors. First of all, you can check whether the power supply and wiring port are loose or the wires are not compressed, which may cause the air compressor host to be unbalanced. Secondly, the failure of the current transformer or controller may also cause this problem. At this time, you can judge by checking the three-phase voltage and motor current. In addition, if the three-phase voltage is unbalanced, the current will also be affected, which may cause equipment failure. At the same time, if the voltage is stable but the current is unbalanced, it may be caused by motor failure.

In addition to the above electrical reasons, mechanical problems may also lead to screw air compressor host imbalance. For example, main bearing failure, stator and rotor mismatch, improper installation, and lack of timely cleaning and maintenance can all be potential causes.

When solving the problem of unbalance of the screw air compressor host, you can take the following measures: First, confirm and replace the faulty main bearing, stator, rotor and other components to ensure the matching accuracy and installation quality between them. Secondly, the screw air compressor should be installed and debugged correctly to avoid the imbalance problem caused by improper installation. Finally, the equipment is cleaned and maintained regularly to extend its service life and reduce the failure rate.

If you still cannot solve the problem after trying the above methods, it is recommended that you seek professional help to ensure the safety and normal operation of the device. At the same time, for the maintenance and maintenance of the screw air compressor, it is recommended that you pay enough attention to prevent the recurrence of similar problems.