2026-04-10Views：
Check Method for Self-start and Stop Problems Found by Permanent Magnet Variable Frequency Air Compressor?
1. Electrical parts:
the permanent magnet variable frequency air compressor suddenly stops during operation. First check whether there is a fault prompt, and check if there is a fault prompt. If it does not continue to start, check the reason. When using an air compressor, it is recommended to check whether the permanent magnet variable frequency air compressor is normal, whether there is a focus on electric shock, and replace new parts if there is one.
2. Controller:
the controller has a shutdown delay during use, which means that the main controller is broken and needs to be replaced. Since no one presses the shutdown switch while working, it is impossible for the machine to display the shutdown delay. Remember that there are no signs of failure at this time.
3. Fuse:
when the permanent magnet variable frequency air compressor starts normally, during the star-delta conversion process or when the load operation is shut down, first check whether the fuse is a fuse and whether it is a fuse. Check again whether the motor and head are stuck. At this time, the overcurrent should be stopped, and it is recommended to check the motor and magnetic head.
4. Intake valve failure:
the valve cannot be closed during unloading while still inhaling, causing the high pressure to close.
5. Oil core blockage:
the quality of lubricating oil is poor, and long-term use of lubricating oil may cause oil blockage. The internal pressure of the machine is high, and the oil is lower than the high temperature of the machine. Under normal circumstances, the internal and external pressure difference between the oil core and the core shall not exceed 1kg.
6. Fault of emergency stop switch:
if the emergency stop switch fails, the machine will also stop working, and the failure of the pressure or temperature sensor will cause the machine to stop working.
Shanghai granklin group specializes in producing [water lubricated air compressor] manufacturers, you need [oil-free air compressor] can contact us at any time, inquiry telephone number: 13918023456
A large amount of condensed water will be produced during the working process of the air compressor, which must be discharged in time in order not to affect the normal operation of the unit. There are two main ways of condensate discharge, manual discharge and automatic discharge. Manual discharge has a disadvantage. If the staff forgets to discharge, it will lead
There are many types of air compressors. If they are divided into two types according to the lubricating oil method: one is an oil-free air compressor and the other is an oil-lubricated air compressor. These two kinds of air compressor equipment have their own advantages and disadvantages. Today we will analyze the advantages of oil-free air compressor.
When purchasing water lubricated air compressors, the factory often asks about 75kW air compressors. After the sales manager Shen of Shanghai granklin group air compressor company learned about it, it turned out that this enterprise was used to produce food. because food safety was very important, our sales manager chose the new water for our customers.
The variable frequency air compressor adopts variable frequency speed regulation, the permanent magnet synchronous motor has good efficiency, high power factor, wide efficiency range, which can ensure extremely high operating efficiency and greatly improve the power saving rate in the entire speed regulation range. The permanent magnet synchronous motor (PMSM) runs with low noise. Air compressor frequency conversion
With the renewal and replacement of the times, the traditional oil-injected screw air compressor has received the impact of the market. More and more users are more inclined to use micro-oil and oil-free air compressors. On the one hand, the country is becoming more and more strict in environmental governance. On the other hand, it is in the long-term life of enterprises.
The semiconductor industry is undoubtedly an industry that needs to break through the technological blockade in the next 10 years. In the global semiconductor industry, the development of the domestic semiconductor industry is relatively late. In the process of gradually breaking through the technological blockade in various industries, semiconductor companies are also gradually expanding the scale of the industry. In the semiconductor industry, the "oil-free compressed air" of the "water-lubricated air compressor" It is an important role in development.
When the air compressor is in use, when the air humidity is high, there will be more water after the compressed air. If the air is dry in winter, there will be less water. If it is troublesome to put it, it is recommended to install an automatic timing discharge device, and the cost of self-operation should be 300 or 400. According to the air compressor
Air compressor can operate correctly and has a long service life, excellent maintenance is important, so we must grasp the air compressor maintenance methods, master how to repair common problems. Maintenance of air compressor must do a good job in basic maintenance and maintenance of key parts
Air compressor as the power equipment of production-oriented enterprises, buy the air compressor is not appropriate, the loss is too big, not only the money to buy the air compressor, but also the huge electricity costs, as well as high maintenance costs, more important.
Oil-free, clean, dry and hygienic gas source creates a good treatment environment for doctors and patients; lasting and stable gas source ensures the operation; low noise, energy saving, high-quality parts, reduce end customer expenses and increase service life.
2018 Granklin Group. All rights reserved 沪ICP备18000439号-2
