2026-04-10Views：
What oil is added to the air compressor needs to be determined according to the type of air compressor. Small piston air compressor generally use ordinary mechanical oil can, viscosity is not too high on the line. If it is a screw air compressor or sliding vane air compressor, it is necessary to use special lubricating oil. Air compressor oil mainly plays the role of lubrication, cooling, rust prevention, cleaning, sealing and buffering. Its type is roughly divided into three types: synthetic oil, semi-synthetic, mineral oil;
air compressor with what oil? Air compressor oil function analysis:
1) Lubrication: It is to lubricate the screw host to form a lubricating oil film between the rotors;
2) Sealing function: mainly to fill the leakage gap between the rotor and the housing;
3) Cooling effect: mainly means that it can effectively control the temperature rise caused by the heat release of the compressor;
4) Noise reduction effect: The injected oil is a viscous fluid, which has absorption and damping effects on sound energy and sound waves. Generally, after fuel injection, the noise can be reduced by 10-20 decibels, that is: dB(A) because the air compressor oil is divided into: Mineral oil and synthetic oil. Because of its inherent composition is different, under normal circumstances, the service life of mineral oil is about half shorter than that of synthetic oil.
Mineral oil: under the condition of good unit temperature and working conditions, the service life can reach about 3000-4000 hours. If the air compressor is operating under the condition of more dust and pollutants, it is recommended to replace it at about 2500-3000 hours.
Synthetic oil: Under the condition of good unit temperature and working conditions, the service life can reach about 6000-8000 hours. If the operating conditions are in a dusty and multi-fiber environment, it must be replaced after 6000 hours.
The screw air compressor is an oil-injected single-stage twin-screw compressor. It adopts high-efficiency pulley transmission to drive the main engine to rotate for air compression. The compressed air in the main engine is cooled by oil injection. The air and oil mixed gas discharged from the main engine are coarse and fine. Two separate
Air compressors are generally classified into the following categories: 1. According to the gas transmission volume, to put it bluntly, the gas transmission volume refers to the volume of the gas discharged from each minute of the air compressor during operation, calculated to be sucked in. The small and medium-sized exhaust volume is less than 10 cubic meters/minute, and the small and medium-sized exhaust volume is 10~100 cubic meters
How to purchase 3 cubic oil-free air compressor? GW22A produced by granklin group can reach 3 cubic meters of gas volume under 0.8Mpa pressure. The greater the amount of gas, the greater the need for screw air compressor motor and head. Procurement screw air compressor, must be based on their own industry characteristics, the use of gas pressure and flow demand to select.
View detailsWith the increase in equipment demand, the water-lubricated oil-free air compressor industry is a supporting industry in many fields, so its role is very important.
The textile industry's requirements for compressed air are not only the oil content in the air, but also water and impurities. However, in these three items, the oil is more difficult to completely filter, so the quality of the gas used can be said to determine the grade of a textile enterprise. So how do you want to buy oil-free air compressors in the textile industry?
View detailsMany people are familiar with air compressors, but it is not clear why a jar is used for what it is. The gas tank, as the name suggests, is a tank used to store gas. But its role is not only to store gas, the following is to give
Energy saving has always been a hot topic in the whole society. How to reduce the energy consumption of enterprises and greatly improve the production quality and efficiency. Large energy consumers "air compressor" equipment often occupy most of the energy expenditure of enterprises, and the best way to save and reduce energy consumption is to use "variable frequency energy-saving air compressor".
View detailsWhen purchasing water lubricated air compressors, the factory often asks about 75kW air compressors. After the sales manager Shen of Shanghai granklin group air compressor company learned about it, it turned out that this enterprise was used to produce food. because food safety was very important, our sales manager chose the new water for our customers.
The solution to the water in the air of the air compressor is as follows: 1. There is a drain valve at the bottom of the air compressor cooler. As long as the drain valve is opened immediately, the water inside can be drained clean. 2. You can also install a drain valve at the lowest end of the air compressor storage tank, or
In some industries, the more widely used models are power frequency units. This type of unit is composed of a pair of male and female rotors meshing in parallel with each other to rotate in the cylinder, so that the air between the rotor cogging continuously produces periodic The volume changes, the gas will follow the rotor shaft
2018 Granklin Group. All rights reserved 沪ICP备18000439号-2
