2026-04-09Views：
Q: Does the water in the water-lubricated air compressor need to be circulated? Why?
Answer: The water-lubricated air compressor uses circulating water. The water that meets the water quality requirements enters the water-lubricated air compressor water tank, and the water in the air compressor head is replaced periodically.
The water in the water vapor pass is also constantly being replaced. Water in the process of reuse, continuous replacement to prevent excessive microbial impurities caused by compressed gas does not meet the standards.
The main reason why semiconductors require oil-free compressed gas is that any grease can contaminate the chip, which in turn affects the performance and reliability of the product. In the semiconductor chip manufacturing process, oil-free compressed air is required to ensure the cleanliness of the production environment
Air compressors are used to compress gas. The compressor is similar in construction to a water pump. Most air compressors are reciprocating piston type, rotating blades or rotating screws, and their noise control mainly adopts three aspects: muffler, muffler tunnel and sound insulation technology.
The operation of the screw air compressor for 10 hours is completely normal. In fact, the design of the screw air compressor is usually able to support continuous long-term operation. However, this does not mean that it does not need to be properly maintained and maintained. In order to ensure that the screw air compressor
To obtain oil-free compressed air, the following methods and technologies can be used: 1. Definition and principle of using oil-free air compressor: oil-free air compressor does not use lubricating oil during compression, thereby avoiding lubricating oil entering Compressed air, directly output low oil or connected
If the pursuit of high efficiency and energy saving, pure compressed air and intelligent management, the use of Shanghai Granklin Group water lubrication technology of permanent magnet variable frequency air compressor is a better choice.
The pressure range of compressed air varies with application scenarios and equipment requirements, generally between 0.2 and 1.6MPa(2 to 16bar). The following is the specific pressure analysis under different scenarios: 1. general pressure range for conventional industrial applications: about 0.7MPa(7bar) typical use: drive
Answer: The twin-screw air compressor performs well in many aspects, with high mechanical reliability, excellent dynamic balance, smooth operation and strong adaptability. In addition, the twin-screw air compressor overcomes the single-screw air compressor.
The pressure required for compressed air drying varies depending on the application scenario, the characteristics of the object being cleaned and the desired cleaning effect. The following is an overview of the pressure required for compressed air drying in some different application scenarios: 1. Common pressure ranges for general industrial applications: in one
Air compressor has been working does not stop, may be caused by a variety of reasons. The following are some possible reasons and corresponding solutions: Possible reasons and solutions Causes of pipeline leakage: There is a leakage problem in the compressed air pipeline, and the air compressor will be unable to reach it.
The air compressor is oil-free, but the specific choice should be judged according to the actual demand and application scenario. The following is a brief description of the oil-free air compressor: The oil-free air compressor avoids the use of lubricating oil to ensure the purity of the compressed air. This is
2018 Granklin Group. All rights reserved 沪ICP备18000439号-2
