There are several common faults and solutions of variable frequency air compressor

No matter what kind of equipment of the air compressor, it is inevitable that there will be failures in the operation process, and so will the variable frequency air compressor. The following is a summary of some failures and solutions that often occur in the factory during the operation of the variable frequency air compressor.

1. Unstable voltage

frequency conversion air compressor in the use of the process often appear voltage instability, voltage instability will appear once the load phenomenon, even can not be normal to start the inverter air compressor will cause the change of cylinder pressure. It can be solved by adjusting the regulator in time.

2. The motherboard is damaged

the frequency conversion air compressor will easily cause damage to the mainboard during continuous use for a long time. After the mainboard is damaged, the internal components of the equipment cannot operate normally to release air pressure. Therefore, users need to check the mainboard in time and replace the electronics or mainboard to solve the problem.

3. The cooling fan is damaged

frequency conversion air compressor in the working process will also occur high temperature caused by the inverter fault. At this time, it is necessary to check whether the cooling channel of the inverter is blocked and whether the cooling fan is damaged. If damage is found, it should be replaced in time.

4. Insufficient exhaust

the equipment will also have external input faults during the working process. It is usually necessary to check whether the voltage value of the port is normal, and check whether the short-circuit cap connected between the control panel and the air compressor equipment falls off. The wire short-circuit emergency stop switch can also be used to see if it is damaged. The external input fault can be solved by replacement or installation.

5. External input fault

during the operation of the variable frequency air compressor, there will be external input faults. It is usually necessary to check whether the voltage value of the port is normal, and check whether the short-circuit cap connected between the control panel and the equipment falls off. The wire short-circuit emergency stop switch can also be used to see if it is damaged. The external input faults can be solved by replacement or installation.