2026-04-10Views：
Screw air compressor host imbalance may have the following reasons:
power supply problems: unbalanced voltage or large fluctuations in power supply, and poor contact of a certain phase of the contactor may cause the host to be unbalanced. Check whether the three-phase voltage is balanced. If the voltage is unbalanced, it will directly cause the current imbalance fault.
Motor problems: The motor current is unbalanced, there is a problem with the motor winding or rotor, the internal loss of the motor is too large, and the bearing wear may also cause the host to be unbalanced. It can be judged by checking whether the three-phase winding of the motor is normal.
Controller or current transformer failure: The controller or current transformer failure may also cause the screw air compressor host to be unbalanced. It is necessary to check whether the controller and current transformer are normal.
Wiring problems: loose wiring or wire not tight may also lead to air compressor host imbalance. Need to check the power supply, wiring port is loose.
If the screw air compressor has an unbalanced failure of the main engine, it can be judged and processed through the above points. If you cannot solve the problem, it is recommended to contact professional maintenance personnel for maintenance.
The replacement cycle of the air compressor water filter depends on a variety of factors, including water quality, use environment, working load, and the quality and design life of the filter itself. The water filter element used in the water-lubricated oil-free variable frequency screw air compressor of Shanghai granklin group is replaced every week.
Whether the air compressor room needs anti-explosion or not involves many considerations. The following is a detailed analysis of this problem: Risk analysis of 1. air compressor room Explosion risk: During the operation of the air compressor, if the operation is improper Or the equipment is defective, it is possible
The shutdown sequence of the air compressor and the cold dryer shall be: close the air compressor first, and then close the cold dryer after the system pressure is released. The specific steps and reasons are as follows: Close the air compressor 1. to the shutdown sequence and steps: Press the air compressor stop button, and the equipment will gradually stop.
In the operation process of the air compressor, a series of problems may be encountered. These problems not only affect the normal operation of the equipment, but may also adversely affect production efficiency and safety. The following is a reorganized language of these issues: air compressor operation
In the field of biotechnology, air compressor is the core equipment to ensure production safety and experimental accuracy, in which oil-free water lubrication air compressor has become the preferred solution in this field with its 100 oil-free compressed air and efficient and stable performance.
The method of adjusting the pressure of the air compressor mainly depends on the type of air compressor. However, in general, the pressure of the air compressor can be adjusted in the following ways: Adjust the safety valve: The air compressor is usually equipped with a safety valve to control the pressure.
The starting sequence of the air compressor can be slightly different according to different types of air compressors, but the following basic steps are usually followed: Turn on the total air switch: This is the first step to start the air compressor to supply power to the entire system. Open the air switch of related equipment: in the total
Whether the gas tank is special equipment depends on its working pressure and volume. According to the "Special Equipment Safety Law" and other relevant regulations, when the working pressure of the gas storage tank exceeds 0.1MPa (including 0.1MPa), it is regarded as special equipment. At the same time, if the gas tank
Medical compressed air plays an important role in the medical field. It is a key component of many medical equipment and surgical operations. The following are the main uses of medical compressed air: Power source: Medical compressed air is widely used as a motor for various medical equipment
The shortcomings of the permanent magnet variable frequency air compressor mainly include the following: Oil problem: For the oil-injected permanent magnet variable frequency air compressor, the compressed air contains oil, which may not be applicable in specific industries such as the food industry, because Oil may pollute the product. Rotor
2018 Granklin Group. All rights reserved 沪ICP备18000439号-2
