How to deal with water in air compressor

how to solve a lot of air compressor water?

Some moisture in the air compressor is unavoidable, because the air compressor cannot avoid the moisture in the air circulation during use. However, if there is too much water in the air compressor, then you have to consider whether you have encountered some faults.

How to solve a lot of air compressor water?

1, the general air compressor has its own air-water separator, if necessary, also need to be equipped with air filters, etc!

2, the air compressor supporting the gas tank is a pressure vessel, the manufacturer's qualification examination is very strict. Moreover, the gas storage tank can obtain the pressure vessel license, which proves that the design of the gas storage tank is qualified. According to the national standard, the possibility of corrosion of condensed water has been fully considered in the design of the gas storage tank, and the corrosion allowance of our country is very large. Let me tell you this. As long as it is a gas storage tank produced by a regular manufacturer, you have half a tank of water in the gas storage tank. It is impossible to rust and leak for less than ten years, unless the compressed air contains acidic or alkaline components.

3. The air storage tank matched with the air compressor has a sewage outlet at the bottom, and a ball valve is installed to discharge water vapor regularly. If it is too troublesome, you can also install an automatic drain at the drain outlet of the air storage tank. Remember to have a better quality, otherwise it is easy to block, and it will be useless if blocked.

4. Whether the pipeline design of air compressor is reasonable. The compressed air pipeline is generally required to be inclined by about 1 °. A sewage outlet is installed at the end of the pipeline to discharge regularly. The inlet of the air storage tank should be lowered in and out. If the air is taken from the system pipeline, z * is preferably the pipeline interface of the air storage tank. Above the main pipe, make a 180 ° bend neck down and connect it to the inlet of the air storage tank.