How to effectively reduce the cost of air compressor configuration precision filter

Precision filters are one of the common configurations of air compressor post-processing equipment. What is its function? Why configure the filter?

For reference only:

first of all, because the natural air sucked by the air compressor contains impurities such as moisture and dust, some lubricating oil in the air compressor will become gas after compression. Therefore, the compressed air directly discharged from the air compressor contains moisture, oil and dust. If the compressed air containing the above impurities is directly transported to the pneumatic system, the reliability of the pneumatic equipment system will be greatly reduced and the service life will be shortened. The resulting loss will be very huge, so the correct choice of air compressor filter is very necessary.

In addition, if the air compressor filter is not used, the compressed gas will suck in solid impurities, such as rust falling off the surface of the pipe. If these impurities are stuck in the sliding gap of the directional control valve or the valve seat of the pressure regulating valve, it will cause undesirable behavior.

When the air temperature decreases, the saturated water will dissolve. If water enters the operating circuit and components, it will rust the piping system and components and wash away the lubricating oil film.

In addition, in pharmaceutical, food and other special industrial occasions, it is stipulated that sterilization filters and deodorization filters must be used.

When using a water-lubricated air compressor, the post-processing system also needs to be equipped with a precision filter, because even if the compressed gas is used as a lubricant, the gas will also contain particulate matter. Of course, after the use of "water-lubricated air compressor", we are no longer filtering oil and gas, but impurities in the air.

After using Granklin Group's "air compressor system", the maintenance cost of the precision filter used in the post-processing can be reduced a lot. Compared with the traditional oil injection screw air compressor, it still saves a lot.