2026-04-10Views：
The following points should be noted during the operation of the oil injection screw air compressor:
1, the operation or abnormal vibration, should immediately stop inspection;
2. There is pressure in the operating pipeline. Do not loosen the pipeline bolts and open unnecessary valves, such as traps and drain valves;
3. During operation, when the oil on the oil level gauge is found to be missing and the oil temperature gradually rises, the machine should be shut down immediately. Observe the oil level after shutdown for 5min (the pressure gauge indicates zero). If the oil level is insufficient, add lubricating oil when there is no pressure in the system;
4, should always check whether the automatic steam trap action is working properly, if there is a fault should be immediately overhauled, otherwise the moisture will be brought to the system and cause certain harm to the system;
5. The oil and gas barrel shall discharge sewage at least once a week to prevent the unit from not running for a long time. It is recommended to start up at least 2 hours per week;
6. During the daily operation of the screw air compressor, attention should be paid to whether the pressure switch and joint control program of the air compressor work normally. Abnormal working conditions will lead to an increase in the power consumption of the air compressor. In severe cases, the motor will be burned due to frequent start and stop of the compressor;
7. It is forbidden to operate the air compressor in places where toxic gases may be inhaled, and it is not allowed to block the air compressor suction port during operation.
8. Do not operate under the pressure specified on the nameplate, and do not operate under the pressure specified on the nameplate as much as possible;
9. All doors of the soundproof cover cabinet must be closed during operation.
Air compressor, the full name of the air compressor is the main body of the air source device. It is a device that converts the mechanical energy of the prime mover (usually an electric motor) into gas pressure energy, and is a pressure generating device for compressed air. Is one of the most commonly used in industrial and mining enterprises to provide air power equipment. Usually, the air compressor is divided into screw type air compressor, piston type air compressor and so on.
Air compressor as a new era of general equipment, whenever encountered gas demand, can not be separated from its figure. Let's take a look at the application fields of air compressor with granklin air compressor! Factory Dimension
The water-lubricated air compressor head produced by Shanghai Granklin Group is suitable for coalbed methane mining. The head of water lubricated air compressor has the characteristics of low temperature and high gas cleanliness, and there are many cases in process gas compression. Coalbed methane is a high-quality gas of modern clean energy. Coal mining all over the country is inseparable from water-lubricated air compressors to extract coalbed methane.
View detailsThe full name of the air compressor is the air compressor, which is the main body of the air source device. It is a device that converts the mechanical energy of the motor into gas pressure energy, and is a pressure generating device for compressed air. So how can the air compressor adjust the pressure? If the air compressor is adjusted
The traditional "oil-injected screw air compressor" in the development of "water-lubricated oil-free air compressor", the impact is not small, users due to the upgrading of enterprise product lines, more inclined to use "water-lubricated air compressor", or similar "oil-free air compressor". The construction of a civilized city proposed by the state has higher and higher environmental protection requirements, and the products invested in "water-lubricated air compressors" have also been highly recognized by the market.
Oil-free air compressor theoretically no clearance volume, single capacity, ideal isothermal compression, due to the good thermal conductivity of water, lubricating water into the compression chamber, the temperature will drop to 45 ℃, close to the suction temperature. Oil-free: water to replace oil, lubrication, cooling, sealing, noise reduction of the four effects, to provide 100 oil-free air, no pollution, the discharge of water without special treatment, in line with environmental requirements.
View detailsIn fields such as biology, medicine, electronics, food, medical, automotive, chemical, etc., the water, oil, dust, bacteria, etc. in the compressed air are required to reach a high quality level. However, the water, dust, and bacteria in the compressed air can be passed through a series of filters and dryers.
Energy conservation and environmental protection is always advocated by our country, and the R & D teams of manufacturing enterprises are also trying to develop energy-saving equipment. The screw air compressor, as one of the important gas equipment for production enterprises, will inevitably cause environmental problems in the process of use.
With the growth of enterprises and the improvement of customer requirements, more and more factories will choose the latter between price and quality when purchasing air compressors. But there are also some factories in order to covet the temporary cheap, and choose cheap products, cheap can buy?
The screw air compressor is an oil-injected single-stage twin-screw compressor. It adopts high-efficiency pulley transmission to drive the main engine to rotate for air compression. The compressed air in the main engine is cooled by oil injection. The air and oil mixed gas discharged from the main engine are coarse and fine. Two separate
2018 Granklin Group. All rights reserved 沪ICP备18000439号-2
