Water lubricated air compressor factory direct sale

Air compressor use:

1, can be used as air power-air after compression can be used as power, mechanical and pneumatic tools, as well as control instruments and automation devices, instrument control and automation devices, such as machining center tool replacement.

2. It can be used for gas transportation-air compressors are also used for gas pipeline transportation and bottling, such as remote gas and natural gas transportation, carbon dioxide bottling, etc.

3, for gas synthesis and polymerization-in the chemical industry, some gases by the compressor to increase the pressure after the beneficial synthesis and polymerization.

Granklin Group produces the main products, water-lubricated air compressors.

main sales products: water lubricated air compressor, oil-free oxygen (nitrogen) compressor, explosion-proof oil-free compressor, special gas oil-free compressor, screw compressor, refrigeration dryer, adsorption dryer, filter, gas storage tank, etc.

Low maintenance costs

air compressor equipment-screw air compressor original compressor design saves unnecessary maintenance costs. All components are designed for long life, and the large size of the inlet filter, oil filter and fine separator ensure the best compressed air quality. All oil filters and all types of separator components within the 22kW (30hp) are centrifugal open and close, further reducing maintenance time. "Speed up the repair point" so that the repair work can be completed in a few minutes, downtime and maintenance costs greatly reduced.

Built-in intelligent control

to reduce operating costs, precise operational control is essential. All screw compressors are equipped with an intelligent control system, and the control menu is easy to use.

Working principle diagram of screw air compressor

1 Inspiratory process

the screw air compressor has no intake and exhaust valve group, and the intake only depends on the opening and closing of an automatic regulating valve. When the tooth groove space of the main and auxiliary rotors is transferred to the opening of the intake end of the casing, the space is the largest. At this time, the tooth groove space under the rotor communicates with the free space of the intake port. Because the air in the tooth groove is completely discharged during exhaust, when the exhaust is finished, the tooth groove is in a vacuum state, and the outside air is sucked in and flows into the tooth groove of the main and auxiliary rotors along the axis, when the air fills the entire tooth groove, the air inlet side end of the rotor is turned away from the air inlet of the casing, and the air between the tooth grooves is closed. The above is the "suction process".

2 Closure and conveying process

at the end of suction, the main and auxiliary rotor teeth are sealed with the casing, and the air in the tooth groove no longer flows out, that is, the "closed process". The two rotors continue to rotate, their tooth peaks and tooth grooves coincide at the suction end, and the coincident surface gradually moves to the exhaust end, thus forming a "gas transmission process".

3 Compression process and fuel injection process

during the transportation process, the anastomosis surface gradually moves to the exhaust end, that is, the tooth groove space between the anastomosis surface and the exhaust port gradually decreases, the air in the tooth groove is gradually compressed, and the pressure gradually increases, that is, the "compression process". At the same time of compression, lubricating oil is also injected into the compression chamber and mixed with air due to the effect of pressure difference.

4 Exhaust process

when the end face of the exhaust port of the rotor communicates with the exhaust port of the casing (the gas pressure is the highest at this time), the compressed gas starts to exhaust until the matching surface of the tooth peak and the tooth groove moves to the end face of the exhaust end of the casing. At this time, the tooth groove space between the matching surface of the two rotors and the exhaust port of the casing is zero. The "exhaust process" is completed ". At the same time, the length of the tooth groove between the rotor and the housing inlet reaches the longest, thus starting a new compression cycle.

If you need to purchase a water-lubricated air compressor, please contact Shen of granklin group. we will arrange the best sales for you and provide you with a water-lubricated air compressor scheme.