Granklin Air Compressor Advertising Copy - Welcome to Join and Order

How often do you change the oil of the air compressor?

2026-04-14Views:

The replacement cycle of air compressor oil mainly depends on the type and quality of the oil, as well as the working environment and running time. Generally speaking, the replacement cycle of air compressor oil can be divided into the following situations:

1. classified by oil type

  • mineral oil: Because of its low viscosity, it is easily affected by high temperature, so it needs to be replaced more frequently. It is usually recommended to replace it every 3 to 4 months, or every 2000-3000 hours depending on the operating time.
  • semi-synthetic oil: The viscosity is higher than that of mineral oil, which can provide better protection for the air compressor under high pressure and high temperature. It is recommended to replace it every 6 to 8 months, or every 4000-6000 hours depending on the operating time.
  • Fully synthetic engine oil: More additives, in the face of high pressure, high temperature and high speed and other complex working environment, can better protect the air compressor parts. It is recommended to replace it every 10 to 11 months, or every 6000-8000 hours depending on the operating time.

2. replacement cycle in special cases

  • initial operation of new machine: The newly purchased air compressor must be replaced with new oil after 500 hours of operation, and then replaced according to the normal oil change cycle.
  • harsh environment: If the air where the air compressor is located has many impurities, the air contains corrosive substances, the ambient temperature of the compressor room is high, and the air contains a lot of dust, etc., it may be necessary to replace the oil in advance to ensure the normal operation of the air compressor and extend its service life.

Other maintenance suggestions for 3. air compressor

  • oil filter: The oil filter also needs to be replaced regularly. It is usually replaced 300-500 hours after the first start, and then every 2000 hours.
  • Drive belt: Check the tension of the transmission belt every 2000 hours of operation. If the transmission belt is soft, it needs to be adjusted.
  • Air inlet filter: Maintain the air intake filter once a week to clean the dirt in the inner cavity of the air filter housing.
  • Filter element: Replace the new filter element every 1500-2000 hours to prevent the harm caused by serious filter blockage.

In summary, the replacement cycle of air compressor oil is the result of a comprehensive consideration of factors such as oil type, quality, working environment and operating time. In actual operation, the appropriate oil should be selected according to the specific situation and replaced in accordance with the specified cycle to ensure the normal operation of the air compressor and extend the service life.

More Recommendations

  • 2026-04-13

    Air compressor does not belong to special equipment

    Air compressor does not belong to special equipment, but the following special circumstances need attention: definition and classification: special equipment refers to the life safety, dangerous boiler, pressure vessel (including gas cylinder), pressure pipeline, elevator, lifting machinery, passenger cable

    View details
  • 2026-04-13

    The difference between power frequency machine and permanent magnet frequency converter

    The difference between the power frequency machine and the permanent magnet frequency converter is mainly reflected in the following aspects: Working principle: The power frequency machine is powered by 50Hz or 60Hz alternating current provided by the power supply to control the motor, and its output is a sine wave. Permanent magnet frequency conversion machine is the use of permanent

    View details
  • 2026-04-09

    Can a single screw compressor be idling for 2 hours?

    Screw compressors, including the water-lubricated oil-free inverter screw air compressors of Shanghai Granklin Group, are usually not recommended to run idling for too long without load. Although idling for a short period of time (e. g. a few minutes) may not cause immediate damage, long

    View details
  • 2026-04-15

    What is the main purpose of the water plant air compressor?

    In the waterworks, the main uses of air compressors are concentrated in the four core areas of pneumatic equipment drive, pipeline maintenance and cleaning, water quality treatment assistance, and emergency standby air sources, as follows: 1. Drive pneumatic equipment Pneumatic valves are widely used in the waterworks,

    View details
  • 2026-04-09

    Permanent magnet variable frequency screw air compressor which brand is good

    The water-lubricated oil-free frequency conversion screw air compressor of Shanghai Granklin Group adopts advanced water lubrication technology and permanent magnet frequency conversion technology, and has the advantages of high efficiency, energy saving, environmental protection, stable operation, low noise, and convenient maintenance. Specifically, it does not need to add

    View details
  • 2026-04-14

    What is the permanent magnet inverter screw air compressor

    Permanent magnet variable frequency screw air compressor is a combination of permanent magnet motor technology and frequency control technology screw air compressor. It uses a permanent magnet motor as the power source, and realizes precise control of the motor speed through frequency conversion technology.

    View details
  • 2026-04-13

    Screw air compressor frequency conversion is good

    When discussing whether the screw air compressor uses frequency conversion technology better, the water-lubricated screw air compressor produced by Shanghai Granklin Group provides us with a powerful answer. The application of frequency conversion technology in screw air compressor is undoubtedly an important technological innovation.

    View details
  • 2026-04-10

    Is the refrigeration compressor air dryer special equipment?

    Refrigerated compressed air dryer (refrigerated compressor air dryer) is a kind of special equipment. This is because it belongs to the pressure vessel equipment, used to process air, by removing water vapor and gas impurities in the compressed air, so that the air becomes more dry and pure

    View details
  • 2026-04-09

    Screw air compressor noise how to return a responsibility

    Screw air compressor noise may be caused by a variety of factors. The following are some possible reasons: Mechanical problems: The mechanical parts of the screw air compressor, such as bearings, gears, etc., may produce noise if they are worn or damaged. Regular inspection and maintenance of these departments

    View details
  • 2026-04-15

    What is the displacement on the air compressor nameplate

    The displacement on the nameplate of the air compressor (usually marked as "volume flow" or "displacement") is the core parameter reflecting the performance of the air compressor. Its definition, unit and importance are as follows: 1. Definition Displacement refers to the specific import state (standard work

    View details