2026-04-14Views：
During the operation of the air compressor, if it is shown to exhaust every few minutes, this behavior is usually called "intermittent exhaust" or "periodic exhaust". This exhaust mode is not a continuous exhaust process of the air compressor, but a periodic exhaust operation at certain time intervals.
Intermittent or periodic venting may be triggered by the compressor's control system according to a preset program or pressure demand. In some application scenarios, in order to meet specific process requirements or energy saving purposes, the air compressor may use this exhaust method. For example, in some occasions that require precise control of compressed air supply, or when the air compressor needs to cooperate with the operating rhythm of other equipment, intermittent exhaust may be used.
It should be noted that the specific implementation manner and time interval of the intermittent exhaust or the periodic exhaust may vary depending on the model, specification, and application scenario of the air compressor. Therefore, in practical applications, the appropriate exhaust mode should be selected according to specific needs and conditions, and the normal operation and efficient work of the air compressor should be ensured.
For air compressors, oil-free and oil-free models have their own advantages and applicable scenarios, so it is impossible to generalize which is better. The following is a comparison of the two: Advantages of oil-free air compressors: High air quality: The gas discharged by oil-free air compressors does not contain oil, so it is very suitable for air conditioning
The oil content of the compressed air of the oil-free air compressor can reach level 0. According to industry standards such as ISO 8537-1 or ISO 8573-1, Class 0 requires an oil content of less than 0.01 mg/m & sup3;, which is usually considered equivalent to the oil content grade of oil-free compressed air.
The cold dryer is not a part of the air compressor, but a post-processing equipment used in conjunction with the air compressor. The cold dryer, the full name of the freeze dryer, uses the principle of freezing and dehumidification to cool the saturated compressed air from the upstream air compressor to a certain level through heat exchange with the refrigerant.
In order to avoid equipment performance degradation and discover potential problems in time, it is recommended that the standby air compressor be started at least once a week, and each operation time should be no less than 5-10 minutes. Such a frequency can not only ensure that the equipment will not age due to long-term non-use, but also can be found in time
Air compressors need to discharge water regularly, mainly to prevent condensation from accumulating in the compressed air system, which can cause a series of equipment failures and operational problems. The following is a detailed explanation: 1. the causes of condensed water air compression process: Air Compressor
The system operation energy consumption of air compressor is high, mainly due to equipment selection, system design, operation management, environmental factors and energy waste and other aspects, the specific analysis is as follows: 1. equipment selection and configuration unreasonable low energy efficiency equipment: early configuration of air compressor
In a factory environment, conventional air pressure usually refers to atmospheric pressure, that is, the pressure exerted by the air in our surrounding environment on the surface of an object per unit area. Generally speaking, the conventional air pressure of the factory is similar to the standard atmospheric pressure, which is defined as 101325 Pa S.
Answer: When the gas requirements are high, it is necessary to choose an oil-free air compressor. There are many oil-free air compressors on the market, so we must judge whether it is really oil-free.
The air pressure of the industrial compressed air used in the general factory will be determined according to the specific application and equipment requirements. In most cases, the common compressed air pressure range is usually between 7bar and 10bar (Note: 1 bar & asymp; 100,000 Pa = 1
The formula for calculating the oil content of air compressors in ppm(parts per million, parts per million) is not directly given because it involves the mass content of lubricating oil in unit volume of air. However, we can understand this plan through some indirect methods or transformation relationships.
2018 Granklin Group. All rights reserved 沪ICP备18000439号-2
