How much pressure does the factory air compressor need?

The pressure requirements of a plant air compressor depend on a number of factors, including the production process, the type of equipment and the job requirements. The following is a summary of some common factory air compressor pressure requirements:

general industrial use:

in most industrial production areas, such as auto repair, wood processing, metal processing, etc., the air compressor output pressure is usually 68bar(0.60.8MPa). The air flow in this pressure range is large, which can meet the needs of different degrees of impact, cutting, clamping and so on.

Special industrial use:

higher pressures may be required for certain processes or equipment. For example, aerodynamic equipment typically requires a pressure of 0.8 to 1.2MPa. In the aerospace industry, due to the high requirements of components, air compressors may need to provide a higher pressure of 10 to 14bar(1.0 to 1.4MPa).

Light duty applications:

for some light industrial applications or laboratory environments, lower pressures may be required. For example, micro air compressors are usually used to provide a pressure of 1 to 5bar, while the pressure range of light air compressors is usually between 5 and 10bar.

Adjustment and security:

when the factory uses the air compressor, the pressure of the air compressor should be adjusted according to actual needs. Too low pressure will cause tools and equipment to fail to work properly, affecting production efficiency; while too high pressure may damage components, increase energy consumption, and reduce equipment life.

Safety is the primary consideration, so the factory must strictly abide by the safety operation procedures when using the air compressor to ensure that the maximum pressure range of the equipment is not exceeded.

In summary, the pressure requirements of the air compressor used in the factory vary from application to application and need to be selected according to the specific situation. When selecting an air compressor, a professional or equipment manufacturer should be consulted for accurate pressure demand information.