2026-04-10Views：
The air compressor has been working without stopping, which may be caused by a variety of reasons. Here are some possible causes and solutions:
controller failure:
check whether the display panel of the controller is working normally. If there is any abnormality, the controller may need to be replaced.
Sensor problems:
check whether the pressure and temperature sensors are working normally. If the sensor is found to be faulty, replace it with a new one.
Driveline fault:
check whether the belt is severely worn or whether the gear is worn, and replace it with a new belt or gear if necessary.
Power and circuit problems:
check whether the power cord is in good contact and whether the circuit is damaged. If there is any problem, repair or replace it.
Incorrect pressure setting:
adjust the pressure setting of the equipment to the normal working range to ensure that the equipment can automatically stop after reaching the set pressure.
Poor lubrication:
regularly check the condition of the lubricating oil, replace the lubricating oil or lubricating parts, and clean the lubrication system to reduce friction and prevent the machine from being difficult to stop.
Gas outlet flow reduction:
clean the gas filter to ensure it is unobstructed, and check the sealing device, adjust or replace the seal to prevent gas leakage.
Cooling system failure:
check whether the amount of cooling water is sufficient, whether the cooling pipe, tube plate and other components are well matched, and make necessary adjustments.
Pipeline leakage or inlet valve problem:
check whether there is air leakage in the pipeline, repair it in time, and ensure that the intake valve is normally opened and not damaged.
For the above possible reasons, should be one by one investigation and the corresponding maintenance or replacement parts. During inspection and repair, be sure to pay attention to safety to avoid accidents. At the same time, regular maintenance and maintenance of air compressors is also an important measure to prevent such problems. If the above methods cannot solve the problem, it is recommended to contact professional maintenance personnel or equipment manufacturer for further inspection and maintenance.
Although both of them are designed to remove moisture from objects, their working principles and applicable scenes are quite different! First, let's talk about the dryer. The suction dryer is like a magical magician, it uses the principle of negative pressure
The service interval for air compressors usually depends on several factors, including the type of air compressor, the environment in which it is used, the workload, and the manufacturer's recommendations. In general, most air compressors require regular maintenance to ensure their performance, efficiency and longevity.
The oil content standard of oil injection air compressor may vary according to different models and uses, but in general, for oil injection screw air compressor, the oil content of compressed air is usually not more than 3ppm (that is, the oil content in compressed air is not more than 3 mg per cubic meter)
Oil-injected rotary air compressor is a mechanical equipment that uses motor drive to compress air through rotary motion. Its working principle and characteristics can be summarized as follows: Working principle Inside the oil-injected rotary air compressor, the rotor is installed in a coaxial outer barrel and inner barrel
In general, air compressors are designed to maintain a specific pressure range to ensure that they can meet the needs of various application scenarios. Generally speaking, the pressure of the conventional air compressor is maintained at a certain level, which is
As an advanced compressed air equipment, water-lubricated oil-free air compressor has many advantages, especially in the products of Shanghai Granklin Group. The following are some advantages of describing water-lubricated oil-free air compressors: 1. Environmental protection and friendliness:
There are significant differences between oil-free air compressors and oil-free air compressors in many aspects. The following is a detailed comparison: oil-free air compressors use lubricating oil for lubrication and cooling without lubricating oil. It is possible
The main differences between the integrated air compressor and the split air compressor are reflected in the structure, energy efficiency, maintenance cost and application scenarios. Structure: The integrated air compressor integrates all components into one body, with compact structure and easy installation. It goes through the tube
Air compressor plays a vital role in industrial manufacturing, and its role is mainly reflected in the following aspects: Power supply: Air compressor can provide compressed air, which is an important power source. In industrial production, many equipment and tools are needed.
The application of air compressor in the mining industry is very extensive and important, mainly reflected in the following aspects: drilling and mining: in the drilling process, compressed air can drive the rotary drill bit, its role is similar to that of the jackhammer, and improves the drilling efficiency. In addition, in mining operations
2018 Granklin Group. All rights reserved 沪ICP备18000439号-2
