Startup sequence of air compressor and cold dryer

The starting sequence of the air compressor and the cold dryer is actually like a tacit cooperation in our daily life. Imagine if we were to prepare a big dinner, always need to boil water first, and then put the ingredients in the pot, so as to ensure that the food is cooked just right. Similarly, for air compressors and cold dryers, there is also a sequence of "boiling water first, then putting food.

Usually, we will start the air compressor first to make it run stably, just like boiling water first. The role of the air compressor is to provide compressed air, which is the basis and power source of the entire system. Only when the air compressor is running stably and sufficient compressed air is provided, the subsequent equipment can work normally.

Then, we will start the cold dryer, which is like putting the ingredients into the pot and further processing the compressed air. The cold dryer can remove the moisture and impurities in the compressed air to ensure that the air quality meets the requirements of use. If the cold dryer is started first without a stable supply of compressed air, the cold dryer will not work properly and may even be damaged.

Therefore, in order to ensure the stable operation of the whole system, we should start the air compressor first, and then start the cold dryer after its stable operation. This sequence not only protects the equipment, but also ensures efficient operation of the system. Of course, during the operation, we also need to pay attention to safety and follow the instructions and operating procedures of the equipment.