First open the air compressor or dryer

When starting the air compression system, it is usually recommended to turn on the air compressor first, and then turn on the dryer. This is because the air compressor is the source of compressed air, and only by starting the air compressor first can compressed air be generated for the dryer to process. If the dryer is turned on first and there is no compressed air supply, the dryer will not work normally.

Therefore, the correct starting sequence should be to turn on the air compressor first, and then turn on the dryer for drying after the compressed air is generated and stabilized. This can ensure the normal operation of the entire system and increase the service life of the equipment. Of course, in the specific operation, the starting sequence should also be determined according to the actual situation of the equipment and the specific requirements of the system.

In addition, for the use of air compressors and dryers, the following points need to be paid attention:

before starting the air compressor, check whether the parameters of the equipment are normal, such as oil level, pressure, etc.

After opening the air compressor, wait for a period of time to allow the compressed air to be stably generated before opening the dryer.

During use, the equipment should be inspected and maintained regularly to ensure its normal operation and extend its service life.

In short, the correct starting sequence and daily use and maintenance are important links to ensure the normal operation of the air compression system.