How often is the screw air compressor maintained correctly

The maintenance cycle of the screw air compressor depends on many factors, such as the equipment model, the use environment, and the workload. However, in general, the following are some general maintenance recommendations:

maintenance of the air filter element: It is recommended to check it every three months. If the filter element is found to be severely blocked or damaged, it should be replaced in time. Usually it should be replaced after 2000 hours of operation, or in places with particularly harsh environments (such as foundries, ceramic factories, glass factories, etc.), it is recommended to replace it every three months.

Maintenance of the oil filter: The oil core should be replaced in time after the new machine runs for 500 hours for the first time, and the oil drum should be cleaned. After every 2000 hours of operation, the oil filter and the impurities in the oil drum should be replaced. However, please note that the replacement cycle should be shortened in the harsh use environment.

Maintenance of the oil and gas separator: usually it should be replaced after every 3000 hours of operation, or it should be replaced in advance in a harsh environment. The specific service life of the oil and gas separator will be affected by the environment, temperature, humidity and air quality of the air compressor.

Oil maintenance and replacement: the new machine should be replaced after 500 hours of operation, and then the second replacement time is 2000 hours after operation, and then every 2000 to 3000 hours. When changing the oil, it is best to change the oil filter at the same time. Please note that the replacement cycle should be shortened in harsh environments.

Cleaning of the cooler: at least once a year, or adjust the cleaning frequency according to the environmental conditions. There will be blockages inside the cooler, and the outside may also be covered with dust or catkins. These may cause the heat dissipation effect to decrease, so it needs to be cleaned regularly.

In addition, there are some daily inspection and maintenance work that need to be paid attention to, such as regularly checking whether the safety valve, electric control box, motor junction box and other components are in good condition, regularly checking the tightness and wear of the transmission belt, and regularly checking the intake control valve, The working status of valves such as the minimum pressure valve, the temperature control valve, and the solenoid valve.

In general, the maintenance cycle of the screw air compressor should be flexibly adjusted according to the actual situation, not only to ensure the normal operation of the equipment, but also to avoid waste caused by excessive maintenance. It is recommended to refer to the maintenance manual provided by the equipment manufacturer and to consult a professional technician for more accurate advice.