2026-04-10Views：
The oil position of the screw air compressor is usually located in the oil circuit system of the compressor and is an important part of the screw air compressor. Specifically, the oil system of the screw air compressor includes oil tank, oil filter, oil separator, oil cooler, oil pipe and other parts, and the oil separator is one of them.
The main function of the oil separator is to separate the lubricating oil and the compressed air inside the compressor to ensure the purity of the compressed air and prevent the oil and gas from damaging the internal components of the compressor. At the same time, the oil separator can also improve the efficiency of lubricating oil and extend the service life of the compressor.
In the screw air compressor, the oil separator is usually installed at the outlet of the compressor to separate the oil and gas in the compressed air in time. Some high-end screw air compressors will also use multi-stage oil separation technology to improve the effect of oil and gas separation.
It should be noted that the performance and service life of the oil separator will be affected by many factors, such as the working environment of the compressor, the working load, and the quality of the lubricating oil. Therefore, when using a screw air compressor, it is necessary to regularly inspect and maintain the oil separator to ensure its normal operation and extend its service life.
The above information is for reference only, if necessary, it is recommended to consult professional and technical personnel or air compressor manufacturers.
There is a direct correlation between the gas production and frequency of the variable frequency air compressor. This relationship is mainly reflected in the following aspects: First, the variable frequency air compressor controls the operating frequency of the compressor by adjusting the speed of the motor. When the frequency increases, the motor speed increases accordingly
In the evaporation system, the air compressor mainly provides compressed air to stir the plating solution, assist vacuuming and control the vacuum degree. At the same time, some equipment uses its power to drive mechanical components to ensure the uniformity, stability and efficiency of the evaporation process. The following is for its
The amount of water in the air is measured in terms of relative humidity, not directly in ppm (parts per million). Relative humidity refers to the content of water vapor in the air and the percentage of saturated water vapor content at that temperature. Therefore, we cannot directly give null
The noise level of the air compressor is affected by many factors, including the type of air compressor, power, operating status, and whether noise reduction measures are taken. The following is an overview of the noise level of air compressors based on publicly released information: 1. General air compressors
When discussing the cost of air compressor per cubic meter of air, we have to mention the water-lubricated air compressor produced by Shanghai Granklin Group. With its high efficiency, energy saving, environmental protection and oil-free characteristics, it stands out in the market and provides users with A cost-effective compressed air solution.
Yes, the air compressor will automatically stop pumping when the air pressure reaches the set value. The working principle of an air compressor usually includes a pressure switch (or pressure sensor and control system) to monitor the air pressure in the air tank. When the air pressure is lower than the set minimum value, the air compressor starts and
Air compressor nameplate is an important way to understand its parameters and models and other important information. Here are some ways to view and understand the nameplate of the air compressor: 1. the nameplate position The nameplate is usually located on the side, back or control panel of the air compressor. Before viewing the nameplate, you need to first
Medical air compressor is a special equipment for the hospital to produce clean compressed air, and water lubricated air compressor because of water instead of oil, so that the production of air is more pure, especially suitable for use in hospitals such a place with high air quality requirements, silently guarding the safety of patients.
In modern industrial production, nitrogen, as an important industrial gas, is widely used in various fields. In order to meet the market demand for high-quality nitrogen, Shanghai Granklin Group has launched an advanced water-lubricated screw air compressor with its unique technology and excellence.
Question: What size of air compressor is needed per hour for 75 cubic meters of air volume? Answer: If the air volume required per hour is 75 cubic meters, then 1.25 cubic meters per minute. If the Granklin water lubricated air compressor is 11kw, the gas production of 8kg of conventional pressure can meet the requirements. Snail
2018 Granklin Group. All rights reserved 沪ICP备18000439号-2
